Issues programming trunks for TMDI

[New950]

I am attempting to program TIE trunks for a TMDI PRI card on a CS1000. I have already programmed the DDB, CEQU, DCH, Net data, and RDB. However, while attempting to program the 23 trunks in LD 14, I receive err SCH0126: "Station type conflicts with existing card.For example: In LD 11, the craftperson has attempted to provision a digital set in the same IPE slot as an existing ITG card."

Any ideas on how to remedy this?

 

[bhassell2000]

is your RDB built as TIE? the RDB and Trunks have to match

Thanks,

Buddy

Linked in Profile

http://www.linkedin.com/in/buddyhassell

 

[New950]

Yes I have configured the RDB to reflect TIE trunks. I have also attempted to use COT

 

[RickyPone]

Post your programming.

 

[Reveleo]

Any solution to this issue..

we are having the same problem.. after installing a new CS1000E, we are not able to add the pri trunks.. we receive the sch0126 error. The loop is 4. The card sits in slot 1..

we tried to add tie trunks to TN 4 0 1 x but the system responded with the above error..

advice on this please..

Cheers!
Rev