Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

ISDX Change Board

Status
Not open for further replies.

joehawkins

Programmer
Jul 25, 2007
71
GB
Hi Folks

I have been asked to change a card in a 2 shelf isdx the faulty extension card is on 0114, from memory i think its the following procedure, please advise if correct or not.

Down card 0114 plug umbilical into card and to shelf interface card, swap card up card.

Is that correct or am i wrong?

Thanks

Joe
 
That would be correct.
DCD 0114
or
CDN 0114 for 'courtesy down'

Plug in the umbilical and remove the card
Plug umbilical into new card and insert preferably using the inserter

UCD 0114
 
Thanks sbcsu one other question just shelf 0 = the bottom or top shelf?

Thanks

Joe
 
Well in the example 0114 it would be shelf 1 and slot 14

If the shelves are not physically labelled I normally make sure by LSLT - list the slots and compare physically.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top