ISDN / WCBRI Problem

[RKuehn]

Hi,
i have some problems how to set up an ISDN BRI Line correctly. I should be a normal wcbri station (connected on a TN556 Board) with etsi standard. Normally an ISDN line has 2 B-Channels, but i am currectly only able to use 1 Channel at a time. I have a Fax-Server ISDN card connected to it and want that the card uses the 2 Channels simultaneously.
How can i do this?
I hope someone can help me !

 

[kva]

Try to use data module with type wcbri instead of station.

 

[dimas]

Hi

Station form "into the studio"...

 

[RKuehn]

Hi Dimas,
what do you mean by "Station form into the studio"?
I have tried to use data-module instead of station -> same problem. I can set up a connection with 2 channel (channel-bundling) to ONE calling-number, but not 2 connections to different numbers.

 

[dimas]

Sorry RKuehn, i mean to ask you to show us screen form of wcbri station .
Did you set data-module: yes on first page and assign data module number on last page?
Have you option of double B-channel dialing in your fax-server software.
What speed of fax connection you have?
Does your outside channel provider support isdn-calls with more than 64 kbps speed?

 

[roche]

RKuehn, Have you got this working yet? If not then paste the station configs here so we can look at them.

Roche.

 

[RKuehn]

Hi !
thanks for your answers. At the moment i try to make a tracing file from our Fax-Server Software (that i was told by the tech-support from the fax-server manufactorer).
Perhaps a little silly question: How do i paste the station form in here? I am not able to copy it in DSA.

best regards

 

[roche]

Use the emulator within DSA and type the command display data xxxx. Then with the mouse highlight the station data, right click and select copy then paste it in tek-tips. Do the same for both pages in the station form.

 

[RKuehn]

The copy-paste doesn't work, perhaps my DAS Release 1.0.17 German is too old. I do not get an pop-up menu when i click right in the emulator window :-(

 

[defone]

Hi,

Is it a Brooktrout faxcard? If so try configuring your
BRI-port into a BRI-trunk.

Regards

 

[RKuehn]

Hi,
it is a faxcard from ferrari-electronic.
Now it works!! i have replaced the TN556 Circuit Pack, it seems, that the BRI Line card was defective.
Thanks a lot,
rigobert

 

[MauroB]

Hi,
We are Mauro & Nick from Milan (Italy).
We suggest You try to config the Tn556 board as a Bri trunk and add a trunk.
Then You can route the fax calls to this trunk by aar or ars dig. conv. .
In this way You can use many than one incoming fax number.
Keep in mind the You can config the board as staions/datamodules or as bri trunk.