ISDN to desktop Help

[RDECIT]

We have a 3300 MXe early v9 build.

It has a T1/E1 combo card and a Quad BRI

All links out of the T1/EI are fine but we are trying to get to dial out of the BRI we can get anything.

This was working as a Mitel Engineer set it up for an ISDN fax server, the fax server is now dead but the config was left in place. The card is setup for S Bus type and were using a cross over cable. We are trying to dial out from a pc using an ISDN modem, but it appears we get no layer 2.

 

[tlpeter]

You probably need a terminator for this
The terminator must be 100ohm !

ACS - Implement IP Office
ACA - Implement IP Telephony -- ACA - Design IP Telephony
ACA - Voice Services Management
______________
Women and cats can do as they please and men and dogs should relax and get used to the idea!

 

[RDECIT]

This is sorted, the BRI card had thrown a fit. We found port 4 wroked fine when using an ISDN simulator.

I used the LOAD <PLID> and the other ports came up fine.