ISDN PRI on Si G3V8i.04.1.046.6

[optionsleft]

I am going to convert my existing T1 robbed-bit to PRI, can somebody tell me exactly the license & hardware do I need.

ISDN PRI is set to "y" in the customer-options already

Procedures:
1. ch ds1 xxxx - signaling to isdn-pri
2. add signaling group x -
3. add data module - type=proc-intf
4. change trunk group to isdn and assign the members

Anything I missed?

Thanks a lot.

mwooks

 

[Mitch672]

Its actually easier if you remove the programming from the existing T1, because you will have issues of not being able to change things. Remove all members from your existing trunk group, remove DS1 01AXX.

Now you can change the trunk group to PRI, and add the DS1 back in as an ISDN PRI, I don't think you need to mess with data channels on R8.4, that was pre R8.2 I believe.
Add a signalling group, assign it to say 01AXX24, and the trunk group you are using.

Add the members back into the trunk group, and you should be almost done.

the signalling group should come up first, once thats up the members will go in service/idle.

You will also need to do a "change isdn pub", and setup the public unknown numbering, you may also have ot modify some of the outbound routes as well.

good luck

mitch


AVAYA Certified Specialist

 

[optionsleft]

Thanks mitch. I will do this one tomorrow.