ISDN PRI link to NORTEL Meridian

[seetu]

Please tell me what is the Interface parameter in Nortel to link with Definity G3 Si Release 11 using ISDN PRI.
I am able to make incoming calls to definity , but not outgoing calls. Please help!!

 

[velcrobomb]

You have a Nortel Meridian at a different site. You've linked them via ISDN-PRI. You can make calls from the Nortel to the Definity but you aren't able to make outgoing calls from the Nortel?

Please explain your set up a bit better. I'm also interested in how you've gotten as far as you have.

 

[seetu]

Now the situation is imporoved better after I routed the calls through AAR. Details are as follows..
Programmed One DS1 card to link to Nortel.
Settings for DS1 are Bit rate-2.048,lincode-hdb3,sigmode-isdn-pri,interface-peer-master,connect-pbx,protocol-Q-sig,side-a, etc.,
Created sig group with settings-grouptype-isdn-pri, assoicated, supp protocol-b.
Created a trunk group for isdn pri,with access code, codeset 6,
I found that Nortel was sending the prefix also , so I deleted 2 digits in digit handling.After that I was able to receive calls from Nortel.When I call Nortel with access code , I get Intercept tone. But when I route the call through AAR , the call is through.
In nortel Interface is set to ESS4.
Now the problem is
I don't get name display - only number is displayed on either side.
Please advise.