Does anybody know about this problem.
I have one 4000 (R1) with isdn interface and one
cisco 1600 (R2) whith isdn interface. R1 does always make the connection to R2. idle time out is 3600 on both routers.
After successful connection R2 have an virtual access interface:
//
Virtual-Access1 is up, line protocol is up
Hardware is Virtual Access interface
MTU 1500 bytes, BW 64 Kbit, DLY 100000 usec, rely 255/255, load 3/255
Encapsulation PPP, loopback not set, keepalive set (10 sec)
DTR is pulsed for 5 seconds on reset
Time to interface disconnect: idle 00:55:51
//
How can I close "Time to interface disconnect" beacuse after exactly 55minutes and 51seconds the connection will be disconnected. I've noticed that the counter starts from
1 hour and countdown, exactly like idle timeout on both routers.
Something can of course be misconfigured, I can post the conf if it's needed.
I'd greatfull if someone have the answer to a solution.
I have one 4000 (R1) with isdn interface and one
cisco 1600 (R2) whith isdn interface. R1 does always make the connection to R2. idle time out is 3600 on both routers.
After successful connection R2 have an virtual access interface:
//
Virtual-Access1 is up, line protocol is up
Hardware is Virtual Access interface
MTU 1500 bytes, BW 64 Kbit, DLY 100000 usec, rely 255/255, load 3/255
Encapsulation PPP, loopback not set, keepalive set (10 sec)
DTR is pulsed for 5 seconds on reset
Time to interface disconnect: idle 00:55:51
//
How can I close "Time to interface disconnect" beacuse after exactly 55minutes and 51seconds the connection will be disconnected. I've noticed that the counter starts from
1 hour and countdown, exactly like idle timeout on both routers.
Something can of course be misconfigured, I can post the conf if it's needed.
I'd greatfull if someone have the answer to a solution.