Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Is there any copy commands with the UCX? 2
- Thread starter hawks
- Start date
-
1
- #2
GordonKapesMZ4
Programmer
YES!
First plug in an unregistered T7316 into the system.
Then on the extensions page in the GUI, click Bulk Add.
Then choose the extension you want to emulate.
Then below, type in the number of the new extension you want to create.
Click Submit.
On the phone press Config, then enter 82950 for password and enter the new extension number for the phone.
The phone should come up. Let me know if it works.
Joe
"Keep the Peace, Use RLS"
First plug in an unregistered T7316 into the system.
Then on the extensions page in the GUI, click Bulk Add.
Then choose the extension you want to emulate.
Then below, type in the number of the new extension you want to create.
Click Submit.
On the phone press Config, then enter 82950 for password and enter the new extension number for the phone.
The phone should come up. Let me know if it works.
Joe
"Keep the Peace, Use RLS"
-
1
- #3
Easy!
1. Build the INITIAL set the way you want it built such as button programming, Shared Call Appearances,etc.
2. Go to PBX\Extensions- Bulk Add Nortel
3. Select the Extension you built in Step 1 as the Template and put the new Extension Range in the box below it.
You will then be shown a screen where you can change the set Names, Voice Mail Passwords, etc.of the new sets you are about to create.
When finished, select "Create Extensions"- And you are DONE!- This process is actually easier than Set Copy on BCM becasue you cna make the required changes BEFORE you create the actual extensions.
I hope this helps, have a blessed day!
Stocking Distributor for E-Metrotel
1. Build the INITIAL set the way you want it built such as button programming, Shared Call Appearances,etc.
2. Go to PBX\Extensions- Bulk Add Nortel
3. Select the Extension you built in Step 1 as the Template and put the new Extension Range in the box below it.
You will then be shown a screen where you can change the set Names, Voice Mail Passwords, etc.of the new sets you are about to create.
When finished, select "Create Extensions"- And you are DONE!- This process is actually easier than Set Copy on BCM becasue you cna make the required changes BEFORE you create the actual extensions.
I hope this helps, have a blessed day!
Stocking Distributor for E-Metrotel
- Thread starter
- #4
Ok what if they want to make changes to multiple sets that are already working. What they did was move some people around and now they want to change to match the group they're with now. wasn't sure if you could copy like Norstar or even if there's a way to upload from excell or something.
No, the sets would need to be individually changed at this point. Once the extensions are created, the changes are on a one to one basis. No Set Copy feature...
Stocking Distributor for E-Metrotel
Stocking Distributor for E-Metrotel
- Thread starter
- #6
I was going to suggest that, but that isn't always the "desired method" by the installer! 
Stocking Distributor for E-Metrotel
Stocking Distributor for E-Metrotel
- Status
Similar threads
- Locked
- Question