You have to go into your code section for your form. Select the form name, go to your toolbar and look for the multicolored square; the tooltip will say "Code". Click on this. You are now in the form's code window. There are two drop down boxes near the top. One says "General". Drop this box down and select "Form"> The second box says "Declarations". Drop this down and select "Load". You should now see:
Private Sub Form_Load()
'Place your code here
End Sub
Place your code (in this case Docmd.Maximize) here.
The Missinglinq
"It's got to be the going,
not the getting there that's good!"
-Harry Chapin
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.