Is it possible to do multiple appearance DN with ATA and IP phone? 1

[imunbob]

Hi,

I've set up an ATA (i3micro VRG 142) for use with an analog DECT phone.
ld 87
REQ new
CUST 0
FEAT cdp
TYPE dsc
DSC 8078
FLEN 4
DSP
RRPA
RLI 2
NPA
NXX
DSC
(rest of it like this:

http://www.tspforum.com/node/27)

The ATA/DECT work as expected but now I want to add the DN to a IP phone but can't figure out how to do it.
I get the following error:
Location: 067-0-00-05 Sync Status: CHG
Could not be CHGed after 2 tries.
Prompt: KEY Response: 2 MCR 8078 Error Code: SCH0375
(SCH0375) DN type conflicts with input DN type.
(It' the same with SCR...)

Is it possible to do some kind of multiple appearance DN configuration on the ATA so that I can add the DN to other phones?
I don't need multiple calls going on at the same time; just need the DN to appear on both phones.

Software:
cs1000: ver 2121, rel 400T
signaling: sse-4.00.55

 

[PERRYPJ]

You can't put 8078 on a phone it's a DSC

OLD ROLMEN WORKING ON NORTELS AND AVAYA

 

[imunbob]

Thanks for answering.

Yea I didn't have high hopes for that to work
I have only the work done by the previous maintainer of this system to look at. He has put the "DN" as DSC and then set DN prefix as the same number as DSC in NRS and H323 Id on the ATA...

Is what I'm trying to accomplish doable?

 

[Reusser]

DN can not be a DSC and a appearance on phone - Number conflict.

Feature called PCA or Mobilex will allow two diffent numbers to ring at same time. Maybe this will help you if youe phone is one number and ATA andother and both ring from same call using PCA or Mobilx

 

[imunbob]

PCA looks like the solution to what I'm trying to do, but we don't have licenses... will have to consider if this warrants the licensing cost.
Thanks for the help.