Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Is it possible on an MICS to bypass

Status
Not open for further replies.
ajntek

ajntek

Programmer
Oct 22, 2003
58
US
Is it possible on an MICS to bypass the area code when local 10-digit dialing is required? I'm trying to figure out a way the customer can access a their line pool and make the system auto dial the area code so the user on has to enter only the 7 digit tel number. I've never been asked to set this up before and wasn't sure if it was even possible. Any input would be appreciated. (MICS 5.0 w/LS/DS analog lines)

Thanks!

ajNtek
[ponytails]
 
Sort by date Sort by votes
Yes you can do it using Route & Destinations codes.
 
Upvote 0 Downvote
TELL THEM TO GET USE TO IT

OLD ROLMEN WORKING ON NORTELS
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

P
  • Locked
  • Question
Incoming calls go to dial tone on Nortel MICS-XC 7.0
Replies
11
Views
593
curlycord
curlycord
N
  • Locked
  • Question
Need support on dial 9 Nortel MICS PRI When dial 9 display states Invalid number. Incoming DIDS work fine. Been working for years. Provider 1
Replies
6
Views
823
Nortel dino
N
Don W
  • Locked
  • Question
Mics software upgrade tools
Replies
9
Views
354
curlycord
curlycord
telllman
  • Locked
  • Question
External Paging on Norstar MICS 12 32
Replies
5
Views
280
telllman
telllman
jsaad
  • Locked
  • Question
MICS GATC going dead 4
2
Replies
24
Views
585
curlycord
curlycord

Part and Inventory Search

Sponsor

Back
Top