Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations dencom on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

IPO500 LAN Port

Status
Not open for further replies.
CIDCrane

CIDCrane

Programmer
Mar 19, 2009
172
US
I have a 500v2 on 6.0.14 software and for some reason there is an extreme switch that is getting Rx errors from the PBX when IP Phone traffic starts going up. It was doing the same thing for the VM machine, so I changed the settings on the NIC card to 100MB full duplex from Auto Negotiate. The IPO does not seem to have any settings that I can change on the LAN port. From what I understand the IPO is 100MB Full duplex by default though, correct? Is there a way to change the settings?
 
Sort by date Sort by votes
Not that i am aware of..I tried it earlier couldn't find it.If you think it the LAN port try the WAN port (swap IP )
 
Upvote 0 Downvote
Yeah I tried that as well as switching out the cable. I feel like the IPO is doing its job right, but I did think twice being that the VM machine stopped causing errors when I made a change there.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

JM2009
  • Locked
  • Question
IPO500 embeded VM lost 3 seconds recording 3
Replies
3
Views
779
eaglepromopro
eaglepromopro
JM2009
  • Question
IPO500 call forward no answer in hunt group from a analog trunk line
Replies
6
Views
403
JM2009
JM2009
Nikos Koulioumbis
  • Locked
  • Question
VM PRO on IPO500 9.0.12 does not route calls to menu selection 1
Replies
6
Views
430
TouchToneTommy
TouchToneTommy
JiriPol
  • Locked
  • Question
Avaya IPO500 - analog line distance
Replies
6
Views
475
budbyrd
budbyrd
wilsontec
  • Locked
  • Question
Avaya Ipoffice J139 1G Lan not reach
Replies
1
Views
262
Mo. Abdullah
Mo. Abdullah

Part and Inventory Search

Sponsor

Back
Top