When connecting loudspeaker paging to an IPO Partner Edition 6.1 analog extension port, can I connect directly to an amplifier from the port defined as the Loudspeaker extension to a Lo Z input on the amplifier? If I need to connect to a Hi Z input, can I just use an impedance matching transformer from the port to the amp? I read previous tips regarding a regular IPO stating that a UPAM is not needed unless coming off an analog trunk port ( and wanted to confirm it would be the same on the IPO Partner Edition. Thanks for the help.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
IPO Partner Edition Loudspeaker Paging
- Thread starter tsg063846
- Start date
Use a bogen WMT1A, set the HI/LOW Z strap based on which input you use on amp ( see instructions included in box for z setting ) If you program a button on your phone for all page I would suggest programing it via " Centralized Programing " on the 6.0 it would'nt work otherwise). Not sure if that was resolved in 6.1. You can't have ring over page using this method but it does work.
- Status