Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

IPO Not Recognizing Base and Trunk Card

Status
Not open for further replies.

Gaspagano

Technical User
Jun 27, 2013
35
ZA
I am running IPO 9.0 suddenly the site couldn't make calls when i check System Status i see no cards connected under Control Unit, Its says Base: Empty, Daughter Card:None, I have put a New Base card and a New Trunk Card but the System still dont recognize the cards, I have upgraded to a later patch from 9.0.0 to 9.0.10 and i still have the same error
Cards installed are

Slot 1 Analog Phone 2 Card with a Trunk daughter Card
Slot 2 Analog Phone 8 Card
Slot 4 VCM Card

all these cards are not being recognized
 
They likely plugged a PC into the system and blew a card, try one at a time :)
 
i will try pluging in 1 at a time i have since replaced the Base card
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top