Hi there,
Can attach to DTE port as per FAQ but although AT command generates an "OK" any other such as AT-X, AT-X2 or AT-X3 generates "ERROR".
I am trying to default the unit.
Any ideas?
While you are hooked up to the unit through your pc or laptop, power down the unit. As soon as you apply power back to the IP Office, start hitting your escape key on your pc/laptop immediately. Once messages stop scrolling you should be able to do your AT commands.
If you typed "AT" then type "at-debug" you will get a prompt back then type "eraseconfig" and it will reply with a message then type "erasenvconfig" and wait for a reply then type "reboot" and then after the reboot your unit is back to factory defaults.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.