IPO Anywhere R10 and Select Mode

[IamaSherpa]

Anyone tried to install IPO Anywhere R10 Primary + Secondary Server in Select Mode?

I would test onex-portal resiliency, it doesn't work, I don't know if I miss something or it's because licenses (Select license it's not included in the IP Office Demo Set), even though no warning/alarms from Monitor or SSA.

 

[sizbut]

Select feature needs select license.

Stuck in a never ending cycle of file copying.

 

[IamaSherpa]

I know Sizbut, thank you, but because no alarm or warnings, I wonder if this feature would be anyway supported by the IP Office Anywhere set, I tried to see if anyone was able to set it up in that way.

 

[sizbut]

Select feature needs select license. That's me being polite.

Stuck in a never ending cycle of file copying.

 

[AvayaNACR]

IP Office Anywhere is Standard Edition not Select.

 

[mkoker]

When you load IP Office anywhere if you load the Demo Config you will be in IPO Select. There is only 1 IPO SE Select License in there. If you load the IP Office demo after uninstalling the IP Office Service then you will be in the IPO SE. You can run in select, but you're limited to one node.

NTSDirect

 

[IamaSherpa]

Thank you mkoker, I will try that, it would be great if the session were 2 at least to demo the one-x resiliency, anyway I will try to twin two Se Demo systems loading the Demo Config as you suggested.