Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
ipldk 100 with bribe
- Thread starter Smit666
- Start date
Hey Smitty
Please write exacly what is in your 2 cabinet ipLDK-100.
Also the exact s/w level, and the type of MPBN, ASMU2N etc.
What type of BRIBE is used - the type with processor or the the NBRIBE (without processor).
So write -like this :
MPB:
SLOT1: e.g. DTIB12
SLOT2 ---
SLOT3 : e.g. VMIBE
etc.
Do you have more BRIBE's - and what about the SYNC cable?
///doktor
Please write exacly what is in your 2 cabinet ipLDK-100.
Also the exact s/w level, and the type of MPBN, ASMU2N etc.
What type of BRIBE is used - the type with processor or the the NBRIBE (without processor).
So write -like this :
MPB:
SLOT1: e.g. DTIB12
SLOT2 ---
SLOT3 : e.g. VMIBE
etc.
Do you have more BRIBE's - and what about the SYNC cable?
///doktor
- Thread starter
- #3
tib 24- Thread starter
- #4
Sync cables should be installed from SLOT=5 (OUT) to SLOT=6 (IN). Did you use ferrite cores, also?
Good common grounding is essential.
Does it work with only one ISDN board?
You could move the VMIB up to the second cabinet, as this board takes a lot of power.
Otherwise it looks OK.
///doktor
Good common grounding is essential.
Does it work with only one ISDN board?
You could move the VMIB up to the second cabinet, as this board takes a lot of power.
Otherwise it looks OK.
///doktor
- Thread starter
- #6
- Status