ipLDK 100 Pickup Group Setup

[ptiernan]

Hi All

Don't progam this ipLDK 100 switch much and all prorgamming is done on the reception handset.

Hopeing this will be fairly easy, looking to setup a new pickup group can anyone help with instructions on how to do this.

Much Thanks
Paul

 

[Chamvari]

go to PGM 190/191 or station group programming on the PC admin, pick a group define it and add the members( extension numbers)

Dial Tone shoul be There

 

[ptiernan]

Thanks Chamvari

I dont have PC admin so need to do everything on the reception handset.

Dont have a great knowledge of this so it would be good if someone could give me a workflow on how to do this.

Much Thanks
Paul

 

[TryaReboot]

Hi Paul,

From the attendant handset (normally receptionist)

do 'TRANS/PGM

* # if password protected then enter

if not press TRANS/PGM.

Enter PGM number: 190
Enter Group number: next available ie 620, 621, 622 etc

Flex key 1: Group Type (option 6 for Pick-up)
HOLD/SAVE
Flex Key 2: Pick up att on/off (1 for on and 0 for off)
HOLD/SAVE
Flex Key 3: Members (ext numbers) enter a range ie 100-110 or you can assign individually by using flex key 1 as member 1, flex 2 for member 2 etc etc, also using volume key to move to member 5 - 8 and again for 9-12 and so on.

HOLD/SAVE

Exit using Speaker key.


DONE!

Thanks

Steve