Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

ipLDK 100 Pickup Group Setup

Status
Not open for further replies.

ptiernan

IS-IT--Management
Apr 29, 2003
55
GB
Hi All

Don't progam this ipLDK 100 switch much and all prorgamming is done on the reception handset.

Hopeing this will be fairly easy, looking to setup a new pickup group can anyone help with instructions on how to do this.

Much Thanks
Paul
 
go to PGM 190/191 or station group programming on the PC admin, pick a group define it and add the members( extension numbers)

Dial Tone shoul be There
 
Thanks Chamvari

I dont have PC admin so need to do everything on the reception handset.

Dont have a great knowledge of this so it would be good if someone could give me a workflow on how to do this.

Much Thanks
Paul
 
Hi Paul,

From the attendant handset (normally receptionist)

do 'TRANS/PGM

* # if password protected then enter

if not press TRANS/PGM.

Enter PGM number: 190
Enter Group number: next available ie 620, 621, 622 etc

Flex key 1: Group Type (option 6 for Pick-up)
HOLD/SAVE
Flex Key 2: Pick up att on/off (1 for on and 0 for off)
HOLD/SAVE
Flex Key 3: Members (ext numbers) enter a range ie 100-110 or you can assign individually by using flex key 1 as member 1, flex 2 for member 2 etc etc, also using volume key to move to member 5 - 8 and again for 9-12 and so on.

HOLD/SAVE

Exit using Speaker key.


DONE!

Thanks

Steve
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top