Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

IP400 to Remote

Status
Not open for further replies.

ECCOMMS

Vendor
Jun 23, 2008
12
US
So here is my scenario

I have a SITE A with IP412 and 2 30 DS modules and Cable Connection
12 5610SW

SITE B DSL CONNECTION
Wants to connect 2 5610SW to the SITE A based 412 unit.

How can i accomplish this?

The units are plugged into the 30 DS Modules so its only on the network via LAN one

Can i point the 2 SITE B 5410SW to SITE A WAN IP?

Thanks

Dave
 
What I would do is get a hardware VPN connection between the sites. Then just set your phones to connect to the LAN address of the IPO.

Kevin Wing
ACA- Implement IP Office
Carousel Industries
 
so a FVS114 Netgear and FVS338 should work correct?
 
First you talk about 5610 and later about 5410

Do not forget that the 5410 are DS phones (digital station) and the 5610 is an ipphone witch will not work on a DS module
You need an ipphone to work over DSL
Also you need a VCM card for calling TDM (trunks non ipphones)
You need a VPN router on both sites and if you want to be sure the quality is good then you need QOS but for two phones i do not think it is neccessery


ACA - Implement IP Office
ACS - Implement IP Office
ACA - Voice Services Management
______________
Women and cats can do as they please and men and dogs should relax and get used to the idea!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top