Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

IP trunk from CM to IPO (call denial) denial event 1179: User busy D1=0x41 D2=0x420f11

Status
Not open for further replies.

SenorAvayaGuy

Technical User
Jul 11, 2016
30
MX
Hello users, having issues I hope you can help with. I'm trying to get a call out through a sip trunk from IPO via an IP phone from G450 (IPO is being median for sip trunks as 450 has no SBC controller) Here is my config.


Group Number: 2 Group Type: isdn CDR Reports: y
Group Name: IP Office COR: 1 TN: 1 TAC: 802
Direction: two-way Outgoing Display? n Carrier Medium: H.323
Dial Access? n Busy Threshold: 255 Night Service:
Queue Length: 0
Service Type: tie Auth Code? n
Member Assignment Method: manual

Group Type: isdn

TRUNK PARAMETERS
Codeset to Send Display: 6 Codeset to Send National IEs: 6
Charge Advice: none
Supplementary Service Protocol: a Digit Handling (in/out): overlap/enbloc
Digit Treatment: Digits:

Digital Loss Group: 18
Incoming Calling Number - Delete: Insert: Format:

Disconnect Supervision - In? y Out? n
Answer Supervision Timeout: 0
CONNECT Reliable When Call Leaves ISDN? n
XOIP Treatment: auto Delay Call Setup When Accessed Via IGAR? n

ACA Assignment? n Measured: none
Internal Alert? n Maintenance Tests? y
Data Restriction? n NCA-TSC Trunk Member:
Send Name: y Send Calling Number: y
Used for DCS? n Send EMU Visitor CPN? n
Suppress # Outpulsing? n Format: pub-unk
UUI IE Treatment: service-provider

Replace Restricted Numbers? n
Replace Unavailable Numbers? n
Send Connected Number: y
Network Call Redirection: none Hold/Unhold Notifications? n
Send UUI IE? y Modify Tandem Calling Number: no
Send UCID? y
Send Codeset 6/7 LAI IE? y


Show ANSWERED BY on Display? y






Group Number: 2 Group Type: h.323
SBS? n Remote Office? n Max number of NCA TSC: 0
Q-SIP? n Max number of CA TSC: 0
IP Video? n Trunk Group for NCA TSC:
Trunk Group for Channel Selection: 2 X-Mobility/Wireless Type: NONE
TSC Supplementary Service Protocol: a Network Call Transfer? n
T303 Timer(sec): 10
H.245 DTMF Signal Tone Duration(msec):
Near-end Node Name: procr Far-end Node Name: IPO
Near-end Listen Port: 1720 Far-end Listen Port: 1720
Far-end Network Region: 1
LRQ Required? n Calls Share IP Signaling Connection? n
RRQ Required? n
Bypass If IP Threshold Exceeded? n
H.235 Annex H Required? n
DTMF over IP: out-of-band Direct IP-IP Audio Connections? y
Link Loss Delay Timer(sec): 90 IP Audio Hairpinning? y
Enable Layer 3 Test? n Interworking Message: PROGress
H.323 Station Outgoing Direct Media? n DCP/Analog Bearer Capability: 3.1kHz



Heres what a call looks like ...



11:55:57 TRACE STARTED 10/18/2017 CM Release String cold-02.0.823.0-21388
11:56:06 active station 5556 cid 0x13
11:56:06 G711MU ss:eek:ff ps:20
rgn:1 [10.122.0.62]:2882
rgn:1 [10.122.0.14]:2052
11:56:06 dial 90 route:ARS
11:56:06 term trunk-group 2 cid 0x13
11:56:06 dial 907881241151 route:ARS
11:56:06 route-pattern 66 preference 1 location 1/ALL cid 0x13
11:56:06 seize trunk-group 2 member 17 cid 0x13
11:56:06 Calling Number & Name NO-CPNumber NO-CPName
11:56:06 Setup digits 07881241151
11:56:06 Calling Number & Name NO-CPNumber TEST
11:56:06 denial event 1179: User busy D1=0x41 D2=0x420f11
11:56:06 idle trunk-group 2 member 17 cid 0x13


Anyone familiar with this denial event ??

all help is appreciated.


 
Wow no clue then sorry, maybe someone else on here has an idea
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top