We have a mixed environment of Succession 3.0 & 4.x PBXs...mostly 3.0. For the IP Trunk Cards it is recommened that they be setup as CLS DIP (Dial Pulse). In order to do so, at least at one site, I have to set the SIGO to STD and push the change to the card as well via TM. Otherwise, if I leave the route set to SIGO ESN5, I have to program the trunks as CLS DTN. In going through the programing, we have different IP Trunks set to CLS DTN or CLS DIP. I believe I could switch all the routes to SIGO STD and program the Trunks as DIP, then switch the RDB back to SIGO ESN5....as I believe that was what was done before. However, it would make sense to me to switch all sites to SIGO of STD, which I believe has to be done for them to function with each other...either ESN5 or STD on all sites.
Any thoughts? Thank you...Bryan.
