This one has me stumped.
All I can say is that the configuration for all the phones and softphones (on a single network) on a BCM 200 (r4.0.2.03) is correct. The network is also fine.
I know this because at any one point all phones have been working properly.
It all started when two softphones would register but not connect to server. It would say "Connecting to server..." indefinately. After hours of work with no success, we rebooted the system (no changes) and voila... problem solved.
Then we later noticed that an IP phone in the back room which was hardly ever used would not come up. It did work before the reboot though. So... we rebooted the system again at a pre-determined schedule. That phone came back up, but now another phone is affected by this "Connecting to Server.." problem.
Registering/Deregistering does not solve it. Changing to a different DN does not solve it. It would seem once the phone is registered and cannot connect... it will never connect unless the system is rebooted.
Here is the typical procedure for an affected phone:
1)Phone boots up
2)Asks to be registered (if it is unregistered or deregistered)
3)Registers if needed
4)Logs into system (Element Manager shows IP address as “Online” in the [Telephony]>[IP Apps and Sets] area but DOES NOT show as an Active Set)
5)Phone/Softphone says “Connecting to server…” indefinitely
Note: This is not a network issue or configuration issue because every reboot will let an affected phone back in, but possibly knock one or two others off.
DN Keep Alive is checked for all phones.
There are no digital phones.. all are IP and there are plenty of licenses (15 out of 19 used)
Any ideas anyone?
All I can say is that the configuration for all the phones and softphones (on a single network) on a BCM 200 (r4.0.2.03) is correct. The network is also fine.
I know this because at any one point all phones have been working properly.
It all started when two softphones would register but not connect to server. It would say "Connecting to server..." indefinately. After hours of work with no success, we rebooted the system (no changes) and voila... problem solved.
Then we later noticed that an IP phone in the back room which was hardly ever used would not come up. It did work before the reboot though. So... we rebooted the system again at a pre-determined schedule. That phone came back up, but now another phone is affected by this "Connecting to Server.." problem.
Registering/Deregistering does not solve it. Changing to a different DN does not solve it. It would seem once the phone is registered and cannot connect... it will never connect unless the system is rebooted.
Here is the typical procedure for an affected phone:
1)Phone boots up
2)Asks to be registered (if it is unregistered or deregistered)
3)Registers if needed
4)Logs into system (Element Manager shows IP address as “Online” in the [Telephony]>[IP Apps and Sets] area but DOES NOT show as an Active Set)
5)Phone/Softphone says “Connecting to server…” indefinitely
Note: This is not a network issue or configuration issue because every reboot will let an affected phone back in, but possibly knock one or two others off.
DN Keep Alive is checked for all phones.
There are no digital phones.. all are IP and there are plenty of licenses (15 out of 19 used)
Any ideas anyone?