IP Office with BCM using PRI

[Rossana1702]

Hello,

I have connected an IP Office500v2 7.0 with BCM450 R1 using a PRI(E1) QSIG.
Voice is working, but I can not see names on phones's display (neither of them). Using IPO Monitor, we can see the names of both sides on DCH messaging, but these names are not showing up on phones.

BCM have MCDN and QSIG license.

Anyone of you have implemented this before?, including names?

Thank you.

 

[DBrewsky]

I thought QSIG on the BCM was only supported with an E1/PRI not a T1/PRI. But I could be wrong. Mostly when we would enable the MCDN/QSIG option, it was when setting up a PRI between a Meridian (Option XX, or CS1K) and the BCM.

--DB

 

[AC2]

Setup a User Short code to Send Caller ID