Hi,
Scenario - Power failure due to UPS. Expansion module disconnected and unable to re- connect to system (red light).
Recycling of power and System boots up and works, new (used) expansion added which also works fine.
Can connect via system status but when trying via Manager I get the network error.
I have tried every which way to connect but cannot get past the error on either lan.
I'm going to site today to reset the system? I have a backup config which I can resurrect with some minor changes.
Can anyone give me any best practices when encountering this issue? Or what people have found to be the issue?
I'm hoping this will correct the system logon fault. If not may need a new system perhaps...
Thanks in advance.
Scenario - Power failure due to UPS. Expansion module disconnected and unable to re- connect to system (red light).
Recycling of power and System boots up and works, new (used) expansion added which also works fine.
Can connect via system status but when trying via Manager I get the network error.
I have tried every which way to connect but cannot get past the error on either lan.
I'm going to site today to reset the system? I have a backup config which I can resurrect with some minor changes.
Can anyone give me any best practices when encountering this issue? Or what people have found to be the issue?
I'm hoping this will correct the system logon fault. If not may need a new system perhaps...
Thanks in advance.