Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

IP Office "Bulletin Board" vm box 1

Status
Not open for further replies.

Kn1ght

MIS
May 4, 2007
23
0
0
US
Hey everyone, Im trying to set up a "bulletin board" voicemail box to just play a message without leaving them an opportunity to leave a message....any direction? IP 500 4.1.15
many thanks
 
vmlite, pro or embedded?

y1pzZTEUdok1vrI5cLb3FdPX4PgTPlSONkb5WPjz0x50etSujaMSmhdRCbOx9vASnrRNzzXv0IxNQA

___________________________________________
It works! Now if only I could remember what I did...
___________________________________________
 
create a new module, from start point connect to generic. record a wav file. and then create a sc to voicemail collect ''module name''

y1pzZTEUdok1vrI5cLb3FdPX4PgTPlSONkb5WPjz0x50etSujaMSmhdRCbOx9vASnrRNzzXv0IxNQA

___________________________________________
It works! Now if only I could remember what I did...
___________________________________________
 
thanks man, had to set up a hurricane hotline and quick, thanks again for the quick response!!
 
thnx...you're welcome... :)

y1pzZTEUdok1vrI5cLb3FdPX4PgTPlSONkb5WPjz0x50etSujaMSmhdRCbOx9vASnrRNzzXv0IxNQA

___________________________________________
It works! Now if only I could remember what I did...
___________________________________________
 
if you make VM:module name as a destination in your incomming call route it will go straight to the wave file.

y1pzZTEUdok1vrI5cLb3FdPX4PgTPlSONkb5WPjz0x50etSujaMSmhdRCbOx9vASnrRNzzXv0IxNQA

___________________________________________
It works! Now if only I could remember what I did...
___________________________________________
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top