Just rolled out IP Office rel 9.0.829 New office with combo cards (6 digital, 2 analog and 4 trunks) and have built hunt group for three analog lines to ring all stations, this includes an analog line. I have tried about everything I know to make the hunt group ring the analog phone. Internal calls will ring the station but hunt group calls will not. Is there any trick to this I need to know?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
IP Office Hunt Group Problems
- Thread starter Dweidmann
- Start date
Check your hunt group ring mode. By default, it is usually set to Sequential (Each extension is rung in order, one after the other)
You want collective, or collective call waiting. If You have already made this changes, and merged the configuration, and it still doesn't work, power down, and restart.
Andre
You want collective, or collective call waiting. If You have already made this changes, and merged the configuration, and it still doesn't work, power down, and restart.
Andre
rpavlinich
ISP
If its Basic Edition, go to your Analog Trunk setup and under coverage destination, for each line, assign your analog extension there.
Why not just set each phone up with line appearances? True partner style
Basic edition can get the job done you just have to get used to it.
Why not just set each phone up with line appearances? True partner style
Basic edition can get the job done you just have to get used to it.
- Status