IP Office and Dealer Board system linked by QSIG

[IPOUK]

I've never connected 2 systems by QSIG (dealer board system) - I was just wondering if anyone else has and what programming you think will be needed. I realise you change the line subtype to QSIGA. But what other programming is needed?

Any help would be great...and also any cfg files would be even better!

Cheers.

 

[IPGuru]

1 end of the link needs to be qsiga the other qsigb

create short codes to route the necessary numbers to the qsig line & all should be fine

The IPO treats inbound calls on the qsig circuit as if they were dialed on switch so should work without any problems.
if the remote site is sending aditional digits(node no. etc) then you may bneed to create a short code to strip these as follows

SC <NodeNO>N
Number N
Feature DailExtn.