IP OFFICE 9.0.4 WITH T7208 2

[tekguy125]

Has anyone had any trouble with the T7208 phones on IP Office Standard mode R9.0.4? We are having a lot of problems with the buttons changing and some of the phones are being recognized as M7208 instead of T7208. The error log also shows not M7208 phones not supported. Most of the phones are installed on the new DS30B module but some phones are installed on the TCM8 module in the control unit, most of the problems seem to be on the 30B module. Any help would be greatly appreciated!

 

[sizbut]

If the new system is being installed with a pre-staged configuration that include user button programming, the automatic defaulting of buttons to match the phone type will overwrite the user button settings. This behavior can be prevented by adding the following short code to the user's setup in the pre-programmed configuration: *DCP/ Dial/ 84000004,1,1,0/0. Note that subsequently removing this short code will cause the buttons to return to defaulting according to the phone type.

Stuck in a never ending cycle of file copying.

 

[tekguy125]

Thanks for the tip Sizbut, I think the other problem with the phones being recognized as M7208 is fixed with the patch that just came out...R9.0.5.972