Having a problem with an IPO 500...
I have 2 DS-8 boards, and 2 Legacy boards, each with an ATM-4.
When I boot up, in SSA I see the two ATM4's and the two DS-8's, but in Manager, no lines appear on the "Lines" form.
I have tried swapping which module bay the cards are in, (3&4 with 1&2), defaulting the box, and finally preforming DTE port maintenance, all to no avail.
To complicate matters, during DTE port maintenance, I entered the following:
AT-X3
AT-X2
AT-X1
AT-X
At AT-X the system responded:
"Erase Main Image Storage Area"
Now, the 500 will not boot at all!
I have connected it to a PC running manager with a static IP (192.168.42.2), and I get a BOOTP request, but Manager says it can't process the request.
Any ideas on either problem - the lines or the DTE port maintenance??
I'm stuck!
Jon
I have 2 DS-8 boards, and 2 Legacy boards, each with an ATM-4.
When I boot up, in SSA I see the two ATM4's and the two DS-8's, but in Manager, no lines appear on the "Lines" form.
I have tried swapping which module bay the cards are in, (3&4 with 1&2), defaulting the box, and finally preforming DTE port maintenance, all to no avail.
To complicate matters, during DTE port maintenance, I entered the following:
AT-X3
AT-X2
AT-X1
AT-X
At AT-X the system responded:
"Erase Main Image Storage Area"
Now, the 500 will not boot at all!
I have connected it to a PC running manager with a static IP (192.168.42.2), and I get a BOOTP request, but Manager says it can't process the request.
Any ideas on either problem - the lines or the DTE port maintenance??
I'm stuck!
Jon