IP-GW4E Card: restore defaults?

[TheSniddler]

I programmed an IP Gateway card on a test system for one of our clients, with their IP scheme. Now I have lost what IP address I gave it because I don'tknow which client I was setting it up for. So, when I connect to it with a cross connect LAN cable, I don't know what IP to enter and cannot get in.

Is there a way to clear the settings or restore them to default on this card?

If I can clarify further let me know....any help is appreciated.

 

[cwc3]

you won't do that again

 

[TheSniddler]

So do you have an answer, or just commentary?

I was told on a different forum to put put the card out of service and do a software reset through the maintanence console and that would restore the defaults. I'll try that and if you want let you know if it works.

Thanks Richard.

 

[cwc3]

what does panasonic tech support say?

 

[TheSniddler]

Before calling them I wanted to see if anyone had an idea to try first. I like the forums because I can try ideas when I have time. I'm not usually at liberty to sit in the office and wait/talk with tech support.

Thanks again Richard

 

[cwc3]

well there are a lot of trunk slammers
that have there hands on this equipment and
if you are a legit dealer then why make their
life any easier!!