IP 500 4.1.12 Waiting for Line problem

[victor5908]

Ok-this is a strange one.
I have tried every protocol setting to no avail and I even talked to Catalyst support and they had me add a string to the no user Source Number but still no luck.
Replaced the PRI card-no luck.
In testing with Verizon we could complete calls out when only ONE channel was in service but when we bring the entire circuit in-service,Bam-waiting for Line.We proved this on channels 1 and 23.
I tried programming only the last 4 or 6 for outbound,no deal.
Does anyone have any ideas?

 

[amriddle01]

Providor issue I'd wager, obviuosly not the card, don't they have a ISDN emulator (we use Trend) that can act as a line to the system, I'll bet it works then

ACSS (SME)
APSS (SME)

http://www.ipoffice.tel

 

[hairlessupportmonkey]

yikes! get it off 4.1!

 

[CarGoSki]

Yeah I would bump it up to 4.2.23 then post ISDN traces if it still fails.

Use system monitor unless of course you are a Tard then it IS the fault of the pbx.

 

[victor5908]

OK-sucks being a VERY part time IPO guy.
It is a license issue.
Only 8 channels default without a license upgrade.
Works perfect now.
Thanks all-

 

[amriddle01]

Shouldn't cause that issue though, oh well

ACSS (SME)
APSS (SME)

http://www.ipoffice.tel

 

[CarGoSki]

That may explain it. Since channs 1-8 are active yet you have provisioned from 1-23 then an outgoing call will try channs 23-1.

Use system monitor unless of course you are a Tard then it IS the fault of the pbx.

 

[amriddle01]

Not being experianced with T1's don't they sense when a channel is actually active before using it? As an example on an E1 you can leave all 30 in programming but it will only ever dial out active channels

ACSS (SME)
APSS (SME)

http://www.ipoffice.tel

 

[CarGoSki]

Well it should but 4.1.12 surely hoses analog trunks just as he has described so probably the same for PRI.

Use system monitor unless of course you are a Tard then it IS the fault of the pbx.