Hi everyone. I've set up both an iPhone and an Android smartphone (Samsung Galaxy) with SIP clients and got them registered to my demo IP Office 500v2 R7. I can make and receive calls to the desk phones on out on trunks with no issues, and even pick up parked calls and access voicemail via short codes.
My issue is paging. I can't get the SIP client to use a short code for paging. If I dial a short code (say *99 // dial paging // 3002) all of my phones in group 3002 beep as if the paging is coming through, but my client still says "dialing..."
It appears as if the IPO is not sending an answered status packet (not technical terms, just BS I made up) to the client ext.
Anyone have any suggestions on how to make this work? I've got to figure it out on my demo equipment quick before I have to go on site to an install and look like a fool.
Thanks!
Qz
My issue is paging. I can't get the SIP client to use a short code for paging. If I dial a short code (say *99 // dial paging // 3002) all of my phones in group 3002 beep as if the paging is coming through, but my client still says "dialing..."
It appears as if the IPO is not sending an answered status packet (not technical terms, just BS I made up) to the client ext.
Anyone have any suggestions on how to make this work? I've got to figure it out on my demo equipment quick before I have to go on site to an install and look like a fool.
Thanks!
Qz