I have an individual that has requested to place an international phone call. Is there a CLS that needs to be changed to allow this? Also will it change it for all phones or just one.
You will need to look through LD 90 type will be SPN, and see if 011 is in there. If it is there will be a RLI attached to it go to LD 86 and print out that RLI and see what the FRL is that is the NCOS that the phone will need to be to call International.
If non of this is there then you will have to build it.
<i> "You will need to look through LD 90 type will be SPN, and see if 011 is in there. If it is there will be a RLI attached to it go to LD 86 and print out that RLI and see what the FRL is that is the NCOS that the phone will need to be to call International.
If non of this is there then you will have to build it." </i>
I'm still having a really hard time with this, even after reading the BARS guide! I tried to print ld 90, as above, but before TYPE it asks for the FEAT, and I'm not sure which one to choose!
I have a fax machine that I made the NCOS 7 for (that's the highest), and so the corresponding FRL is 7, but it still won't work. I think that international calling is not "set up". Maybe country code dialing isn't set up, but I can't figure out how to add the codes as dialable or what ever the next step would be.
Of interest, you can still make International Calls without SPN 011. In that case, your SPN 0 processes the call. It's due to that fact that you need to print everything to be on the safe side. However, if someone wanted to print SPN 011, this is how they would do it:
Do you have any phones that can now dial international? If yes - just print one of those phones looking for the NCOS - change the phone you need to dial international to same NCOS.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.