International calls 1

[JEFFFLEM]

I have a merlin legend that has a T-1 (100dna board)that can make long distance calls in North America fine but I can't make International calls , I get a fast busy.Tel co says they are not restricting.I'm not getting call resricted, or turkey tone from PBX .Any Ideas?

 

[Dexman]

I would have the telephone service provider trap digits to make sure that the Legend is sending a valid international telephone number.

 

[dagwoodsystems]

You've got to go to your 011 table and change the call type from I (international) to N (national). In terms of the ISDN call itself, this is expressed as a bit on the D-Channel during call setup. In your situation, altering "the National bit" is the usual trick to solving this.

Check out

http://www.tek-tips.com/viewthread.cfm?qid=1155171&page=1

for details on making this change.

 

[JEFFFLEM]

Thanks dagwoodsystems. between your comment and tie to an earlier thread it fixed my problem !JEFFFLEM