Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

INTERLOOP TEST

Status
Not open for further replies.

SWAFloater

Technical User
Aug 16, 2009
4
US
IS THERE ANY WAY TO CLEAR THE FOLLOWING? HAD AN EARLIER FAULT ON THE SYSTEM MONITOR BUT NOTICED THAT IT WAS OUT OF SEQUENCE PWR000 XSMC 00, 01, 02, 03, 05, FAULT WAS ON 5. CHANGED THE DIP SETTINGS ON 05 TO 04 AND ALL TEST GOOD BUT NOW TRYING TO CLEAR THE FOLLOWING WITHOUT AN INI.

INTERLOOP TEST START.
BSD206 4:4 8 12 13 20 24 29 30

IG_CONT
BSD207 4:17 19

CONT END
INTRA CONT START
INTERLOOP TEST START.
BSD206 4:4 8 12 13 20 24 29 30
 
BSD0206 loop: l1 l2 ln
Loop unable to receive speech from l1, l2, etc. Minor alarm lamp lit on attendant console. Probable fault cause: 1. Network card for loop l 2. If you cannot receive only one loop (l1), there is a possible intermittent fault in the Network card for loop l1. This is the expected fault type if any other loops cannot receive l1 or if L1 appears in a BSD0110 message. 3. If only one loop (l1) cannot be received, possible intermittent fault in one of the peripheral buffer connected to loop l1 4. All other network, conference and TDS cards in the same group.
The following actions correspond numerically to the fault locations listed above: 1. Go to LD 32. Use the commands STAT l and ENLL l to identify and enable disabled loops. Replace the Network card if loops remain disabled. 2. Go to LD 32. Use the commands STAT l and ENLL l to identify and enable disabled loops. Replace the Network card if loops
remain disabled 3. Replace each Peripheral Buffer in turn, starting with the one on the highest numbered PE shelf. The test should then be allowed to run long enough to indicate whether the problem will persist. 4. CFN card status may be checked in LD 34. TDS card status may be checked in LD 38.
Severity: Critical
[/code]

here's the switches opinion of that trouble

john poole
bellsouth business
columbia,sc
 
Thanks John, Looked at that same options but everything looks normal and not sure what to run in LD 45. System Monitor Fault was on that column that's getting all the errors.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top