we have installed a new sdsl line with Pipex - their guidelines have suggested that the dialer interface should be set to "ip address negotiated" however we have been assigned a range of ip's one of which I want to use on the Pipex router as we will then be able to route traffic out of one of our three internet connection (specifying which traffic goes out which connection) this also gives multiple options for backup routes should the primary one go down.
The issue is this
to enable any kind of routing through the Cisco 1721 to reach the internet I have had to assign an external address to a loopback interface (as I want the ability to nat therefore cannot use the internal int). however this causes problems as if the dialer interface goes down any backup routes do not come into play as the loopback is still considered up.
Is there a way of getting the loopback int to track the dialer or atm0 int and set it to a down state when the connection goes down so that our backup routes then work.
If you need any more info I can provide
The issue is this
to enable any kind of routing through the Cisco 1721 to reach the internet I have had to assign an external address to a loopback interface (as I want the ability to nat therefore cannot use the internal int). however this causes problems as if the dialer interface goes down any backup routes do not come into play as the loopback is still considered up.
Is there a way of getting the loopback int to track the dialer or atm0 int and set it to a down state when the connection goes down so that our backup routes then work.
If you need any more info I can provide