Installing TLU76/1

[Devanam]

Hello all,

Recently I have been attempting to install a TLU76/1 into a BC11 MD110. The card installs, and I can program my ROCAI and RODAI on it. However when I attempt to program my ROEQI I get a message telling me that it completed partially. I check and I am missing timeslots 30&31. I try to force program it by doing just those two timeslots and it will not let me.

So, I delete the route and start it all over again. Now it will only allow me to program 1 timeslot total. Below are the commands I am using.

ROCAI:ROU=4,SEL=7110000000000010,SIG=011100000031,TRAF=03151515,TRM=4,SERV=3110000011,DIST=30,DISL=128,BCAP=111111;

RODAI:ROU=4,TYPE=SL60,VARI=15480000,VARO=06310000,VARC=00000310;

ROEQI:ROU=4,TRU=1-1&&1-15,EQU=1-1-60-1;

ROEQI:ROU=4,TRU=1-17&&1-31,EQU=1-1-60-17;

Has anyone seen this and if so, can someone please tell me how to fix it?

Thanks in advance,

Dev

 

[new2md]

hi devanam, do you have license to initiate required trunks. secondly do you have any other free location to change the card and do it all again.

 

[Devanam]

Sorry it's been a while...

Yes, I have more than enough licenses for the trunk. I do have other locations to move to card to.

I have moved the card, and still the same issue. When I try to assign the equipment side of the trunk it is assigning two timeslots and then telling me that I do not have enough equipment room.

Just in case it was something else I was doing, I deleted a current trunk and attempted to put this card in it's spot psyically. Same issue. I then went to return to my base configuration and now my original trunk won't allow me to reinstall more than two timeslots without giving me the equipment error. Luckily I had my system backed up so I restarted it and the trunk came back. Thoughts?

Thank you in advance,

Dev

 

[TeleLion]

Try this:

ROEQI:ROU=4,TRU=1-1&&1-15,EQU=1-1-60-01;
ROEQI:ROU=1,TRU=1-16&&1-30,EQU=1-1-60-17;

regards

To MD or not to MD that is the question

 

[whosrdaddy]

if this is a public route your SERV value in ROCAP is wrong.

change it to SERV=3101000011

-----------------------------------------------------
What You See Is What You Get
Never underestimate tha powah of tha google!

 

[Devanam]

Thank you for the assistance... The link I'm trying to establish is a tie line and not a pulic route.

I tried to offset the ROEQI as suggested but this time it only allowed me to create 1 timeslot for the trunk before giving me the equipment error.

Has anyone seen or heard anything to this effect? I'm willing to try more suggestions.

Thank you in advance,

Dev

 

[whosrdaddy]

if it is a Tie Line then your RODAI is wrong.
D4 of VARO must be set to 0 for Tie lines, or else it will take the wrong license.


RODAI:ROU=4,TYPE=SL60,VARI=15480000,VARO=06300000,VARC=00000310;

-----------------------------------------------------
What You See Is What You Get
Never underestimate tha powah of tha google!