Installing Patches on BCM

[mano3sr1]

Ok, I am new here and semi new to the installation world. What is the process of loading a Patch/es onto a BCM?

I have the patch saved on my laptop and I have access to the BCM via crossover cable.

Where do I go from here or what document can I refer too?


Thanks

 

[biv343]

What model BCM? 50, 200,400? What software release?

 

[mano3sr1]

Oops sorry about that. it is a 200 with 3.6 software.

 

[cook1082]

If you have the patch launch it .It will open up as a wizard enter the IP and password and off it goes.

 

[DigitelD]

Word of advice, Be patient grasshopper!

SHK Certified (School of Hard Knocks)

 

[mano3sr1]

Thank cook1082! Wow, there are a lot.

 

[Crowtalks]

Be forewarned, it can take as long as 30 minutes and do a couple of restarts with no services available for the duration of the patch install.

You might want to consider looking for the cumulative patch 3 and then look for the Daylight savings time patch.

BTW, good luck on the last one (bwhahahah...evil laughing sound from Nortel)