first off...i am not very experienced with file systems...so i may not be taking the right approach...
ok...i went to maxtor's website and downloaded powermax to run a test on the hard drive and it passed...so the drive itself is fine.
i did a fdisk and format of the c drive and now there
are no operation systems. the c and d are partitoned
85% and 15% respectively, but the file system for the
c is fat32 and for d it is ntfs. as i was going
through the setup i selected to have the c drive
converted to ntfs....then as installation proceeded i
received this error:
file vga.sys is corrupted.
then it restartd...so i just went through the setup process again only to receive a similar error:
file vga.sys caused an unexpected error (8192) at line
3183 in d:\expclient\base\boot\setup\setup.c.
if you have any suggestions i would be greatly appreciate!
thanks in advance!
ok...i went to maxtor's website and downloaded powermax to run a test on the hard drive and it passed...so the drive itself is fine.
i did a fdisk and format of the c drive and now there
are no operation systems. the c and d are partitoned
85% and 15% respectively, but the file system for the
c is fat32 and for d it is ntfs. as i was going
through the setup i selected to have the c drive
converted to ntfs....then as installation proceeded i
received this error:
file vga.sys is corrupted.
then it restartd...so i just went through the setup process again only to receive a similar error:
file vga.sys caused an unexpected error (8192) at line
3183 in d:\expclient\base\boot\setup\setup.c.
if you have any suggestions i would be greatly appreciate!
thanks in advance!