install fax finder FF440 on IP Office 8.0

[GhostZman]

I am installing a 4 port Multitech fax finder on an IP Office. I have 4 incoming DID fax numbers. While I understand that i can assign 1 port to each of the fax numbers, I would ultimately like to just send all faxes to a hunt group where it can just get answered by the first available fax port, and then route the call to the correct receipient based on which incoming fax number was dialed. Anyone know if this is possible?

 

[CarGoSki]

That is how the faq describes the default setup.
Create a huntgroup that contains all analog user extensions.
Create fax users that then forward to the huntgroup.
Create ICRs that have the fax users as destinations.