Incoming CLID lost on Assisted Transfer action

[CamIAm]

Since upgrading to VM Pro 4.2.34 calls that are processed by a callflow, using the assisted transfer action, do not present the incoming caller ID on the destination extension set.
If the blind transfer action is used, the incoming CLID is displayed. I've added the variable $CLI to the "source of transfer on the property sheet for the assisted transfer action, but this hasn't made a difference. Thanks for any suggestions.

 

[TomMills]

whats it replaced with? EXTERNAL?

did you upgrade the ip office firmware too?

http://www.twitter.com/tem1985

ACSS-SME
Get well soon Aaron.

 

[CamIAm]

Thanks TM Call display reads: "Voicemail" when the assisted transfer action is used. Have upgraded the IPO as well.

 

[Bas1234]

What does the discription say on the "transfer" in VMPro?

___________________________________________
It works! Now if only I could remember what I did...

Dain Bramaged
___________________________________________