ethereal112
Technical User
I need to block a specific number calling into this system, If someone can clarify what command number to look at and if there's a way I can test it out before leaving this remote site. Thanks in advanced.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Inbound restriction NEC 2000IVS
- Thread starter ethereal112
- Start date
- Status
- Thread starter
- #3
ethereal112
Technical User
I've done this on the 2400 but never on the 2000. How does it work? do you enter the inbound caller ID number to route to a certain destination? Thanks for the response
nerdwannabe
MIS
How have you blocked an incoming call on a 2400? I have a need to do this also.
Thanks,
Thanks,
- Thread starter
- #5
ethereal112
Technical User
Command ACID, basically I blocked it on the inbound route from the local telco. Only problem is the block is for both incoming/outgoing.
- Status
