Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Inactive step of job

Status
Not open for further replies.

Ofina

Technical User
Feb 25, 2004
156
US
I'm not sure if this is the correct forum, but I would like to make a certain step of a job I have inactive. I don't want to get rid of it, but I want it not to run.
Maybe I can just set the step before to go to the step after the inactive one on success and failure.
 
That is how we temporarily 'disable' job steps when needed. Just have the step before it 'go to' the step that you want to run next. That way if you need to re-enable it you just need to change the action back to 'go to next step'.

-SQLBill

The following is part of my signature block and is only intended to be informational.
Posting advice: FAQ481-4875
 
That's right approach.

Ex: Step 5 you want to ignore/inactive then on Step 4 make it on success go to Step 6

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top