Inactive step of job

[Ofina]

I'm not sure if this is the correct forum, but I would like to make a certain step of a job I have inactive. I don't want to get rid of it, but I want it not to run.
Maybe I can just set the step before to go to the step after the inactive one on success and failure.

 

[SQLBill]

That is how we temporarily 'disable' job steps when needed. Just have the step before it 'go to' the step that you want to run next. That way if you need to re-enable it you just need to change the action back to 'go to next step'.

-SQLBill

The following is part of my signature block and is only intended to be informational.
Posting advice: FAQ481-4875

 

[Ofina]

Okay, thanks.

 

[MegaSQLBI]

That's right approach.

Ex: Step 5 you want to ignore/inactive then on Step 4 make it on success go to Step 6