Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

ID Available Station Ports on a Messy Block

Status
Not open for further replies.

dowjonestt

Vendor
Jan 7, 2008
230
US
I have a client with a MICS 8 x 32. THe block is pretty messy with old wiring. I know they are not using all station ports. What is the best way to ID the availbale ports at the block where cross wire is existing.

I want to clean it up for future use so Iwill not have to go thru this every time I need a new port.

THanks!
 
well you have 2 amp cables that come out of a MICS and they go from port 101 to 124 on the 1st amp and 125-132 on the 2nd amp. if your termination blocks are not marked this way you may just want to get into the programming and go under maintenance-port dn status to check for open ports...
 
Went into Maint. and found just what I needed chich were the two lost ports.

Thanks!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top