Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

ICT through VPN

Status
Not open for further replies.

SSgt

Programmer
Nov 5, 2003
88
Hello...we have two clusters at two seperate sites and are trying to connect them via ICT's and eventually a gatekeeper as there are about 12 other sites that we are going to draw together. All sites are firewalled and we need to open the IP/ports. We have voice connectivity between the two clusters on IP phones, however if we call to cluster 1 from cluster 2 and make a call out cluster 1's gateway we don't hear a ringback, the called party's phone rings, once picked up there is no voice, but the call is up. We are currently allowing the following IP traffic through the firewall:

Cluster 1 (Sub, Pubs, phone, and Gateway IP's) can hit Cluster 2 (Sub, Pubs, phone, and Gateway IP's) and vice versa

Cluster 1 phone IP's can hit Cluster 2's phone IP and vice versa

What would be causing this to happen???

Thanks!!!
 
The call-setup is done via specific ports. The call itself is in a specific range of ports. I thought in 32000 and above range. So in my opinion you need to open up the voice-ports in your firewalls to allow traffic from a specific ip-range to the other ip-range using those port numbers.

If I find the documentation about the port numbers I will post it.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top