I am wondering if any of the IBM technicians can help me. We installed the max ram into our x330 (8654-51Y) servers about 2 months ago. We started to notice some odd NMI problems. I read on a previous thread that this was a major issue with IBM product development.
When it scanned the memory at boot up is only shows 3.7G.
I have loaded the 1.06 bios version, but we saw the same problems and the memory scan at boot was still 3.7. Last night I dropped the servers down to 3GB. Jury is still out on this.
Does anyone have a solution or status report on this issue?
We were using a mix of IBM certified RAM and Crucial CC128M72S4R75.36F 1GB 133MHZ CL3 ECC. Now it is all crucial ram.
Any thoughts apreciated!
When it scanned the memory at boot up is only shows 3.7G.
I have loaded the 1.06 bios version, but we saw the same problems and the memory scan at boot was still 3.7. Last night I dropped the servers down to 3GB. Jury is still out on this.
Does anyone have a solution or status report on this issue?
We were using a mix of IBM certified RAM and Crucial CC128M72S4R75.36F 1GB 133MHZ CL3 ECC. Now it is all crucial ram.
Any thoughts apreciated!