Can anybody help me with this one?
We are using an IBM Magstar 3590 tape robot for our back-up 's. With Legato 5.5 we could store about 20 GB per tape and now with version 6.0.2 installed suddenly the physical end of tape is reached at 10 GB. Since these tapes can store 10GB uncompressed or 20 GB compressed, it seems logic that somehow compression (which is set in a directive) doen't take place in the new situation. As far as I know all settings are the same as before.
What can cause this problem? Is it perhaps a driverproblem?
Has anybody noticed this before?
Any help would be appreciated.
thnx in advance,
Remco van Zeist
Amsterdam, The Netherlands
We are using an IBM Magstar 3590 tape robot for our back-up 's. With Legato 5.5 we could store about 20 GB per tape and now with version 6.0.2 installed suddenly the physical end of tape is reached at 10 GB. Since these tapes can store 10GB uncompressed or 20 GB compressed, it seems logic that somehow compression (which is set in a directive) doen't take place in the new situation. As far as I know all settings are the same as before.
What can cause this problem? Is it perhaps a driverproblem?
Has anybody noticed this before?
Any help would be appreciated.
thnx in advance,
Remco van Zeist
Amsterdam, The Netherlands