Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

i200x

Status
Not open for further replies.

I2007

Programmer
Dec 13, 2004
506
NO
I came across a document from Nortel that helped me a lot. Every time I had to restart/boot an i200x phone I had to crawl under the table and then again get up quick enough to punch down theese four menu buttons to get in to the config. Now ther's an easier way to do this.

Press the following combination on the phone:
mute-uparrow-downarrow-up-down-up-mute-release and there you go, restarting....

I hope this was helpful and no one else have posted it earlier, because I didn't bother check it...

Marry Christmas,
i2007
 
Close but not quite.

Dial tone

mute
up
down
up
down
up
9
release


Make sure that Key 0 is the SCR






---------------------------------
PDulfo aka pdiddy
 
Forgot the 9, but I'm pretty sure you can do it without the dialtone. At least if you run 3.10.81 software or later.

mute-up-down-up-down-up-mute-9-release, tried it 1 minute ago...

But thanx, pdulfo...
 
Just trying the other digits.

looks like you can cause some real damage if you want to.




---------------------------------
PDulfo aka pdiddy
 
I2007 Just posted this in the FAQ section. Its something I keep forgetting about. I have included your id for reminding me.




---------------------------------
PDulfo aka pdiddy
 
n1, but are you sure you dont need release at the end or did you forget...?
 
DO you also know the other combinations you can use? If, so post it in the FAQ section too...
 
Doh!!!.

Corrected.

Dont know what the others do. Just started playing to see.


---------------------------------
PDulfo aka pdiddy
 
As an update.

1 Contents of RAM
2 AB06 (?)
3 EEPROM data
4 RX / Q levels
5 TCMLess Intercept
6
7 Test Mode
8 TCM Bert
9 Reset
0 Firmware Revision.


If anybody can help out with these would be appreciated.




---------------------------------
PDulfo aka pdiddy
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top